|
Here
are some general shots of the chassis.
New slides,
crosshead etc. The valve chest link is drven by an eccentric from
the front wheel in the same manner as the C-21 bash earlier. I used
the reverser lift arm from the Annies outside gear for the crank.The
pilot deck has been shortened and the pilot truck is 8mm shorter.
It was just too long as was.
To make the
new rear end to the cylnders you can pull out the Annie's rear end
assembly and remove the gland cover. You can see it here repositioned
on the new back end. Also a pair new motion brackets from 1mm brass,
fixed to the chassis as the original mounts were.Some of the bolt
heads are a tad over scale, but considering all the other compromises
on the model there will be, it's small beer for a robust assembly.
|